Menu
Your Cart

Stertil Koni 5.5 Tonne Two Post Lift

Stertil Koni 5.5 Tonne Two Post Lift
Stertil Koni 5.5 Tonne Two Post Lift

Stertil Koni 5.5 Tonne Two Post Lift:

Special Buy Price £8,295.00 Plus Vat

Delivery Price £695.00 Plus Vat

Total Price £8,990.00 Plus VAT

Price subject to site survey to check for height, width, and depth!

Optional Extra:

Support 40mm                                                         Price £94.00 + Vat for set of 4.

Support 90mm                                                         Price £117.00 + Vat for set of 4.

Support 160mm                                                       Price £148.00 + Vat for set of 4.

Support 250mm                                                       Price £324.00 + Vat for set of 4.

U Shaped Adapter                                                   Price £139.00 + Vat for set of 4.

V Shaped Adapter                                                    Price £157.00 + Vat for set of 4.

Flat Steel Adapter                                                   Price £112.00 + Vat for set of 4

If the above adaptors are ordered and delivered with the lift no carriage charge would applicable, however if they are ordered after the lift has been delivered / installed a carriage charge would be applicable.  The freedom lift models with double telescopic arms have automatic arm locking for added working convenience and safety: Special arm-release handles on the single and double telescopic arms enable easy manual and precise positioning of the lifting arms when the arms are elevated from the floor and close to the pick-up points. The automatic arm locking system is reliable and requires low maintenance. Independent mechanical interlocking of carriages, multi-position arm locking mechanism and innovative sliding block system optimally distributes the load.

Lifting capacity

5500 Kg

Lifting Height

2045mm

Lifting & lowering Time

39 Seconds

Minimum arm length

495mm

Maximum arm length

1430mm

Maximum height of overhead control cable conduit

6200mm

Width overall from base of posts

3655mm

Power Requirements      

3 Phase – 415 Volt 20A Type D Fuses

Operation

Electro-Hydraulic

Locking pawl engaged by gravity.

Locking system is always active even when the 2-post lift is turned off.

Locking profile with locking increments of just 35mm.

Automatic overload protection.

Automatic arm locking.

Ergonomic design with no sharp edges.

Compact foot plates minimise the risk of tripping.

Automatic limiter when highest position is reached.

Hold-to-run buttons on the control panel.

Installation is to a nominally level floor (plus or minus 4mm), prepared site on the UK mainland.

NB: The above prices include delivery and installation on a prepared site, but not electrical works, final electrical connection, civil works or the removal, relocation, or disposal of existing equipment.

A forklift truck and driver when required by the engineers or an alternative will be required to remove the lift from the delivery vehicle and aid in the installation; this is the responsibility of the customer. An “Installation” request form will have to be completed by yourselves prior to installation.

We would be able to carry out a Load Test on the day of commissioning if you supply a suitable laden vehicle to the SWL of the equipment with corresponding weighbridge certificate. If this is not done at the time of commissioning and is required later this will be chargeable to yourselves.

On installation should it be found that the floor quality is inadequate & chemical anchor studs and resin are required, or if the floor is uneven and packing out of posts is required then an additional charge will be made.

The concrete floor will need to be of sufficient depth and quality for the lift to be installed, should it be found the floor is not of sufficient depth and quality and civil works are required (such as new concrete pads or plinths) the price for any civil works is not included.   

Exclusions: The above prices are exclusive of VAT and subject to manufacture’s price ruling at date of dispatch. Also, prices do not include building or electrical works unless specifically stated and are calculated on a clear run basis. Customers may be required to supply lifting equipment for heavy items. Carriage will be charged where applicable. E &.O.E


£0.00
Ex Tax: £0.00
We use cookies and other similar technologies to improve your browsing experience and the functionality of our site. Privacy Policy.